All,
I had a problem with the ATS uplink script. In
the script, the first thig it does Is check for the number of loaded
commands on board. For some reason the TLM point that the script uses is
not updating. The commands that are used to
check the number of commands on-board are working. I tried them
individually and was able to get a response for the number and each
command id. But when I created a table and sent the same commands the
tlm point was not updating. We still have 3 uplink opportunities
for this ATS. I think we need to discuss this on Monday.
The Inertial maneuver was nominal.
Results from the Inertial maneuver:
Q1
0.60160400 ActNor.EstInrToBdy[0]
Q2
-0.33571600 ActNor.EstInrToBdy[1]
Q3
-0.66861700 ActNor.EstInrToBdy[2]
Q4
0.27985500 ActNor.EstInrToBdy[3]
GPS
sec 1316048581 ActNor.EstTime
UTC
time
09/19/2021 01:02:47 output
MPS
Diff
0.805 deg
MPS
Cmd Vector X -0.993233000
MPS
Cmd Vector Y 0.110145000
MPS
Cmd Vector Z 0.036836000
CSS
Angle TLM 0.3304
CSS
Sun-Pointing Angle 0.6608
14
Sept 21 @ 21:30:00
CSS
Angle TLM 1.844
CSS
Sun-Pointing Angle 3.688
19
Sept 21 @ 01:00:00
Pre-Burn
Thruster
1 8352 14 Sept 21 @ 21:30:00
Thruster
2 8160
Thruster
3 9280
Thruster
4 9472
Post-Burn
Thruster
1 8608 19 Sept 21 @ 01:00:00
Thruster
2 8416
Thruster
3 9552
Thruster
4 9744
Number
of Pulses
Thruster
1 256
Thruster
2 256
Thruster
3 272
Thruster
4 272
Thruster
Pairs
Thruster
1 & 2 512
Thruster
3 & 4 544
Timothy
E.Perry
CRS
IBEX OCO-2
Mission
Operations
Office
(703) 406-5976
Cell
(301) 606-1430