All,
I have looked at the orbit 449 ATS,
IBEX_2019_152_o0449a_v001.scr,
and I approve.
The only constraint violations in
IBEX_2019_152_o0449a_v001.ccvr
are from the removal of the
ACT_SetSpinPulseProtectEnable Enable
commands (2); the violations are expected.
The PL commands in the v001 ATS match those in the v002 STF,
IBEX_2019_152_o0449a_v002.stf.
Ascending and descending command sequences are consistent with each other, 15 Re ascending, the apogee maneuver time and 15 Re descending as determined form the OEF,
IBEX_2019_152_o0449a_v001.oef,
and as verified with ibex_orbit.
There is one star tracker outage. The outage starts about 7 hours before perigee and runs for 7+ hours. No despinning should be required due to this outage.
The ground station command sequences are correct and the timing and bit rates match those in the contacts file,
IBEX_Orbit449_Contacts.txt,
for all contacts (3).
We are not doing battery cell balancing this orbit; we'll do it again in the next orbit.
The inertial maneuver at perigee of orbit 448 left us pointing in safe directions for the orbit 449 arc A ascending and descending sequences:
ibex_rotate -o -u 0.37742,0.853224,0.359948 -w ibex-sun -t 2019/06:01:12:20:32
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.377420,+0.853224,+0.359948
which is R.A. +66.138 Decl. +21.097
missing R.A. +68.840 Decl. +21.990 (ibex-sun)
error is R.A. +2.702 Decl. +0.893
for a total 2.667 deg
ibex_rotate -o -u 0.37742,0.853224,0.359948 -w ibex-sun -t 2019/06:05:04:53:17
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.377420,+0.853224,+0.359948
which is R.A. +66.138 Decl. +21.097
missing R.A. +72.707 Decl. +22.477 (ibex-sun)
error is R.A. +6.569 Decl. +1.380
for a total 6.254 deg
The inertial maneuver at apogee leaves us pointing in safe directions at the time of the maneuver and for arc B ascending and descending sequences:
ibex_rotate -o -u 0.306051,0.877478,0.369276 -w ibex-sun -t 2019/06:05:06:36:25
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.306051,+0.877478,+0.369276
which is R.A. +70.772 Decl. +21.671
missingR.A. +72.782 Decl. +22.487 (ibex-sun)
error is R.A. +2.010 Decl. +0.816
for a total 2.034 deg
ibex_rotate -o -u 0.306051,0.877478,0.369276 -w ibex-sun -t 2019/06:05:08:11:31
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.306051,+0.877478,+0.369276
which is R.A.+70.772 Decl. +21.671
missing R.A. +72.851 Decl. +22.495 (ibex-sun)
error is R.A. +2.079 Decl. +0.824
for a total 2.096 deg
ibex_rotate -o -u 0.306051,0.877478,0.369276 -w ibex-sun -t 2019/06:09:19:56:10
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.306051,+0.877478,+0.369276
which is R.A. +70.772 Decl. +21.671
missing R.A. +77.450 Decl. +22.957 (ibex-sun)
error is R.A. +6.678 Decl. +1.286
for a total 6.310 deg
The inertial maneuver at perigee leaves us pointing in safe directions at the time of the maneuver and at orbit 450 apogee:
ibex_rotate -o -u 0.230781,0.8963,0.378665 -w ibex-sun -t 2019/06:09:22:39:31
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.230781,+0.896300,+0.378665
which is R.A. +75.561 Decl. +22.251
missingR.A. +77.560 Decl. +22.962 (ibex-sun)
error is R.A. +1.999 Decl. +0.711
for a total 1.977 deg
ibex_rotate -o -u 0.230781,0.8963,0.378665 -w ibex-sun -t 2019-06-14T19:29:17.261Z
Quaternion +0.000000,+0.000000,+0.000000,+0.000000
points axis +1.000000,+0.000000,+0.000000
towards ECI +0.230781,+0.896300,+0.378665
which is R.A. +75.561 Decl. +22.251
missing R.A. +82.637 Decl. +23.265 (ibex-sun)
error is R.A. +7.076 Decl. +1.014
for a total 6.603 deg
No Lo O-mode.
There is no overlap with orbit 448 commands by manual inspection or by checking at
http://ibex.unh.edu/cgi-bin/ats.cgi.
Command Approval Checklist is attached.
Ken
On May 20, 2019 at 11:04 AM "Perry, Timothy" <Timothy.Perry@ngc.com> wrote:
All,
Attached are the planning files for Orbit #449
Please respond to this thread with comments and approvals.
Approvals are required by 22 May 2019 @1600z.
Please note the following:1. No Battery Balancing
2. Command Load Constraint Violation Report (CCVR)
# Filename: IBEX_2019_152_o0449a_v001.ccvr
# File type: Command Load Constraint Violation Report (CCVR)
# IBEX_2019_152_o0449a_v001.scr
==========================
HARD CONSTRAINT VIOLATIONS
==========================
NO VIOLATIONS.
==========================
SOFT CONSTRAINT VIOLATIONS
==========================
IBX-CLC-016: No command to enable spin pulse protection was found after
transition to science mode at 2019/06/01 10:17:33 UTC
IBX-CLC-016: No command to enable spin pulse protection was found after
transition to science mode at 2019/06/05 07:41:31 UTC
==============
OTHER MESSAGES
==============
NO MESSAGES.
Timothy E.Perry
CRS IBEX OCO-2
Mission Operations
tim.perry@orbitalatk.com
Office (703) 406-5976
Cell (301) 606-1430
![]()
Notice: This e-mail is intended solely for use of the individual or entity to which it is addressed and may contain information that is proprietary, privileged and/or exempt from disclosure under applicable law. If the reader is not the intended recipient or agent responsible for delivering the message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. This communication may also contain data subject to U.S. export laws. If so, data subject to the International Traffic in Arms Regulation cannot be disseminated, distributed, transferred, or copied, whether incorporated or in its original form, to foreign nationals residing in the U.S. or abroad, absent the express prior approval of the U.S. Department of State. Data subject to the Export Administration Act may not be disseminated, distributed, transferred or copied contrary to U. S. Department of Commerce regulations. If you have received this communication in error, please notify the sender by reply e-mail and destroy the e-mail message and any physical copies made of the communication.
Thank you.
*********************