All,

    The Pass was nominal for CMD and TLM. The Inertial maneuver was successful. The ACE went thru another reset. I executed the following procedures S924-OP31203 Enable/Disable ACS FDC and S924-OP31213 Set Static Z rate. All of the ACS FDC was re-enabled and the Static Z-rate was reset from 4.1596 to 4.17255. The time of the reset was 11/07/18 20:48:00z. The time of the Inertial maneuver was at 11/07/18 11:08:07z.  

 

 

Here are the results from the Inertial maneuver:

Q1               0.07625770                  ActNor.EstInrToBdy[0]

Q2               -0.79315600                ActNor.EstInrToBdy[1]

Q3               0.34129700                  ActNor.EstInrToBdy[2]

Q4               0.49860200                  ActNor.EstInrToBdy[3]

GPS sec        1225290000.000           ActNor.EstTime

MPS Diff     0.584            deg

MPS Cmd Vector X     -0.734850000

MPS Cmd Vector Y     -0.618122000

MPS Cmd Vector Z     -0.279142000

 

 

      Tim

 

 

 

 

Timothy E. Perry

Mission Operations

CRS, IBEX, OCO-2 & TESS

RAPTOR Test Team

timothy.perry@ngc.com

Office (703) 406-5976

Cell (301) 606-1430

 

 
Notice: This e-mail is intended solely for use of the individual or entity to which it is addressed and may contain information that is proprietary, privileged and/or exempt from disclosure under applicable law. If the reader is not the intended recipient or agent responsible for delivering the message to the intended recipient, you are hereby notified that any dissemination, distribution or copying of this communication is strictly prohibited. This communication may also contain data subject to U.S. export laws. If so, data subject to the International Traffic in Arms Regulation cannot be disseminated, distributed, transferred, or copied, whether incorporated or in its original form, to foreign nationals residing in the U.S. or abroad, absent the express prior approval of the U.S. Department of State. Data subject to the Export Administration Act may not be disseminated, distributed, transferred or copied contrary to U. S. Department of Commerce regulations. If you have received this communication in error, please notify the sender by reply e-mail and destroy the e-mail message and any physical copies made of the communication.
 Thank you. 
*********************